| PR-2 FEATURES / LEVER BAR DENT PULLING KIT: CLP-100 | ||
|---|---|---|
 |
By using the short weld shaft
and the lever bar, another type of dent pulling can be performed.
The lever bar pulls out the weld shaft, that welds on to the metal, by the operator pulling the handle. Twist the weld shaft to release after welding. Kit consists of: |
 |
 |
||
Back to PR-2 main page
| PR-2 FEATURES / WELD-ON SHAFT DENT PULLING KIT: CLP-110 | ||
|---|---|---|
 |
The Weld-on shaft welds directly onto the work area and pulls
the dent. To release, simply twist the shaft sideways, reposition,
weld, and pull again. This procedure is by far the fastest dent
pulling system on the market, and no consumable washers or studs
are needed. A weld-on shaft weld leaves no hole after the procedure,
just a smooth, dent free surface. When more pulling power is
needed, simply increase the current. The replaceable welding
tip on the weld-on shaft tip will last for over one thousand
welds. Use weld-on shaft for smaller dents such as hale damage. Kit consists of:
|
 |
|
||
Back to PR-2 main page
| PR-2 FEATURES / SPOT HAMMER DENT PULLING: CLP-70 | ||
|---|---|---|
 |
The spot hammer welds directly
onto the work area and pulls the dent. To release, simply twist
the hammer sideways, reposition, weld, and pull again. This procedure
is by far the fastest dent pulling system on the market, and no
consumable washers or studs are needed. A spot hammer weld leaves
no hole after the procedure, just a smooth, dent free surface.
When more pulling power is needed, simply increase the current.
The replaceable welding tip on the Spot Hammer tip will last for
over one thousand welds. Use spot hammer fon any dent. |
 |
|
||